Lathe Technical Safety Operating Procedures

(1) Before operation, lubricate the machine tool as required, check whether all handles are in place, and run the machine at low speed for five minutes to ensure that everything is normal before operation.

(2) The chuck chuck shall be firmly fastened, and the wrench shall not be left on the chuck or chuck when the machine is started.

(3) The workpiece and cutter shall be firmly clamped, and the cutter bar shall not extend too long (except for boring); Stop the machine when turning the small tool holder to prevent the tool from colliding with the chuck, workpiece or cutting hands.

(4) When the work-piece is running, the operator cannot stand directly against the work-piece, do not lean against the lathe, and do not step on the oil pan.

(5) During high-speed cutting, chip breaker and shield shall be used.

(6) It is prohibited to reverse brake at high speed, and the car should be backed up and stopped smoothly.

(7) Remove iron filings with a brush or special hook.

(8) When polishing the workpiece with a file, the right hand must be in front and the left hand behind; Use tools such as "hand clamp" to polish the workpiece with emery cloth to prevent wringing.

(9) All labor, measuring tools and cutting tools used shall be placed in a safe place nearby, in order.

(10) It is forbidden to take workpiece or measure workpiece on the lathe head before the lathe stops stably.

(11) It is forbidden to open or remove the protective device when the lathe is working.

(12) When getting off work, the lathe shall be cleaned and wiped, and the tailstock and slide box shall be returned to the right end of the bed.