Operation and Maintenance of Cnc Milling Machine (Part 1)

After the application of the CNC system in the sawing machine must keep the time, some meta equipment must be aged or even damaged. In order to extend the lifespan of the meta equipment and the use cycle of parts and components as much as possible, and to prevent various faults, especially the occurrence of malignant accidents, it is necessary to protect CNC milling machines. Detailed general protection and maintenance requests are clearly stipulated in the application of the CNC system and the protection statement. To sum up, we should pay attention to the following aspects. CNC Milling machine manufacturer China to share with you :

1. Formulate operating rules and regulations for normal protection

According to the characteristics of various components, determine their own maintenance regulations. As clearly stipulated, which places need to be sorted every day, and which CNC milling machine parts should be heated or replaced on time, CNC system programming, operation and protection personnel need to pass special technical training to understand the CNC of the CNC machine tool used Operating environment and conditions of the system.

Cnc Milling Machine

2. The door of CNC milling machine cabinet and strong electric cabinet should be opened as little as possible

Because dust, oil mist and metal powder float in the air of the machining workshop, once they fall on the circuit board or electronic equipment in the CNC milling machine, the insulation resistance between the equipment is reduced, and even the equipment and circuit board damage. Therefore, in addition to punctual protection and repair, the door of the electrical control cabinet should be opened as little as possible, and the door should be opened during processing.

3. On-time cleaning of the cooling system of CNC milling machine

Generally, the heat exchanger or fan installed on the door of the electric cabinet can circulate the air in and out of the electric control cabinet to promote the heat dissipation of the heating equipment or equipment in the electric control cabinet. Is it normal. Depending on the working environment, check whether the air duct filter is blocked every six months or quarters. If there is too much dust accumulation on the filter net, it needs to be sorted out in time, otherwise it will cause the temperature in the CNC milling machine to be too high, so that the system cannot run reliably, or even cause an overheating alarm.

4. On-time protection of input / output devices of CNC milling machines

Most of the products used in the 1980s are equipped with photoelectric paper tape readers. CNC system parameters, part programs and other data can be input into the registers of the CNC system through it. If the tape reader is contaminated, It will lead to mistakes in reading the information of the person. Therefore, the photoelectric head, paper tape pressure plate and other components should be cleaned on time. The paper tape reader is also the only moving part in the CNC system. In order to make the transmission organization run smoothly, it is necessary to clean and refill the automatic rollers, guide rollers and compression rollers on time.