Safe operation and civilized production of CNC lathes

CNC lathes have high-efficiency processing functions and realize the mass production of parts processing. However, in actual operations, many production accidents have been caused due to illegal behaviors such as violations of regulations, rules, and brutal operations, causing serious economic losses for individuals and enterprises. An operator keeps in mind the safe operation and civilized production process of CNC lathes.

First, safety operation specifications for CNC lathes

1. Personnel without professional training shall not operate CNC lathes.

2. CNC lathe processing personnel must be familiar with the operation manual of the control lathe before operating the equipment, and fully understand its content. It is forbidden to operate the CNC lathe using the steps and methods not described in the operating instructions.

3． When the CNC lathe operator feels physically and mentally unwell, do not operate the machine tool.

4． Operators of CNC lathes should memorize the operation method of the emergency stop button, check it at any time to ensure that the emergency stop button is intact, and report it to the maintenance center if abnormality is found.

5. When an abnormality is found on the CNC horizontal lathe, the operation must be stopped immediately before repairing.

6. CNC lathes must have sufficient lighting facilities around the working environment.

7. Wear safety shoes when operating CNC lathes, and wear goggles when setting the knife.

8. When the CNC lathe fails, the power must be cut off before repairs.

9. During operation, do not place work, measurement, cutting tools or sundries on the slide and protective door of CNC lathe.

10． Do not touch the workpiece or spindle during operation, and do not replace or adjust the workpiece or fixture at will.

11. When moving large workpieces, two or more people are required to operate, and an overhead crane (commonly known as a crane) and a hydraulic truck are used.

CNC Lathe

Second, the civilized production code of CNC lathes

1. The overalls, shoes, hats, etc. of the CNC lathe operator should always be kept tidy.

2. The correct use of CNC lathes and the maintenance of CNC lathe equipment make the equipment always in good condition.

3． The layout of drawings and craft cards should be easy to read, and care should be taken to keep them clean and complete.

4． The cutting tools, cutting tools and measuring tools must be classified and stored in accordance with the requirements of modern CNC lathe factoryfor fixed management. When used, they should be placed under the heavy and green. Less commonly used inside, commonly used convenient place. It should be stored according to the location shown in the tool box, and it should be sorted and counted once at the end of each shift.

5. Finished parts should be stored with station equipment to separate the processing surfaces to prevent collisions with each other and damage the surface. After finishing the finished surface, it should be properly oiled to prevent corrosion.

6. Dress neatly and comply with regulations. Take care of equipment and tools, fixtures, knives, measuring tools.

7. Strictly implement working procedures, scope of work, process documents, strict process discipline, and implement operating procedures.

8. Keep working environment clean and orderly, and civilized production.